8064C Electro/Pneumatic (I/P) Converter
The 8064C Proportional I/P Converter uses advanced closed loop solid-state electronic control to achieve accurate, high resolution pressure control.
It is available in intrinsically safe and non-incendive type nL versions and its minimum vibration effect and IP66 weatherproof rating make it ideal for field application.
Features and Benefits
- Accepts high supply pressure - avoids use of additional regulator
- Factory set for ease of installation
- Lower cost alternative to 8064A
- ATEX hazardous area certification
|Supply pressure:||1.2 to 10 bar||18 to 150 psi|
|Output:||0.2 to 1 bar||3 to 15 psi|
|Supply sensitivity:||Less than 0.1% span over full supply pressure range|
|Flow:||Max 300N l/min (12 scfm)|
|Air consumption:||<2.5N l/min at 50% signal (0.025 cfm)|
|Temperature effect:||Typically less than 0.035% of span/°C between -40°C to +85°C (-40°F to +185°F)|
|Response time:||1 sec (from 0 to 90% or 100 to 10% of output pressure into a 0.5 litre load)|
|Degree of protection:||IP66, NEMA 4X (when mounted upright)|
|Linearity:||<0.1% of span|
|Hysteresis:||<0.1% of span|
The 8064C Electro/Pneumatic (I/P) Converter controls AMOT pneumatic temperature control valves (G valve).
Electro-Pneumatic Valve System
The electro-pneumatic valve system combines both electric and pneumatic technology, consisting of a pneumatically actuated three-way control valve with an electro-pneumatic converter.
The probe sends a resistance signal to the electronic controller, which in turn sends a 4 to 20mA signal to the 8064C I/P converter that converts this to a pneumatic signal.
The electro-pneumatic system combines the features and functionality of the AMOT electronic control system with the fail-safe action benefits of a pneumatically actuated valve.